Platinum to kill lifetime in power diode design

A. Rojas-Hernandez, J. Swart, W. Marzano, A. Garcia-Juarez

Resultado de la investigación: Contribución a una conferenciaArtículo

Resumen

An ultrafast power diode is designed and simulated aiming a simple and low cost fabrication process. It is limited to use not implantation process and to use a deep diffusion. The main parameters to fabricate this structure were studied using SRH and Auger recombination models for the lifetime, Crowell model for impact and high injection current considerations to lifetime. The lifetime reduction was performed by adjusting the parameters of capture cross section and density and Energy-level position of platinum. A breakdown voltage of more than 600 V and reverse recovery times less than 35 ns were obtained for a p+nn+ structure, with an epilayer of 50 μm thickness and doping of 2 to 3 × 1014cm-3. © The Electrochemical Society.
Idioma originalInglés estadounidense
Páginas45-52
Número de páginas8
DOI
EstadoPublicada - 1 dic 2011
EventoECS Transactions -
Duración: 1 dic 2011 → …

Conferencia

ConferenciaECS Transactions
Período1/12/11 → …

Huella

Profundice en los temas de investigación de 'Platinum to kill lifetime in power diode design'. En conjunto forman una huella única.

Citar esto